Esperanto
Shqiptare
Euskara
Zulu
Latinus
Cymraeg
தமிழ்
Slovak
Slovak
Afrikaans
The Steps When We Compress
2018-02-27
The steps when we compress
1. cut the pipe
Cut the pipe with the a cutter, then use special burr remove the device or file to remove the burrs completely in case of puncturing the sealing ring.
2. draw a line
Draw a line with a scriber at bottom of the pipe to confirm the insert length to avoid pipe dropping.
3. insert the pipe
Insert the pipeto pipe fitting straightly, do not puncture the rubber ring, and confirm the length within 3mm between bottom and the line you draw.
4. compress
Make ringlike concave of the jaw alignment ringlike convex of pipe fitting ending with rubber ring, and then make compress.
5. confirm the size
Confirm the size with a hexagon gauge completely, to avoid irregular compress operation.
Something else maybe used when we compress
